Follow these easy steps to get your Zanussi ZEBF 290 SI Refrigerator up and running in no time.
Before using the refrigerator, remove all securing tapes. Wash the inside of the appliance with lukewarm water and a solution of bicarbonate of soda (5 ml to 0.5 litre of water). Avoid using soap or detergent to prevent lingering smells. Dry thoroughly.
Install the appliance in a location where the ambient temperature corresponds to the climate classification indicated on the rating plate. The appliance should be placed in a dry atmosphere, away from direct sunlight and extreme temperatures. It should not be installed near cookers, radiators, or boilers.
Ensure the appliance is electrically connected to a power supply with a voltage and frequency of 220-240 V / 50 Hz. The plug must be easily accessible after installation.
After installation, allow the appliance to stand for 2 hours before turning it on, to let the refrigerant settle.
Plug in the appliance and switch it on at the mains supply. Turn the thermostat control to a midway setting (3-4). Adjust the air circulation slider control, located on the back wall of the fridge section, to a midway position between 'MIN' and 'MAX'. The pilot light will illuminate.
Set the thermostat to the desired temperature between 1 (minimum coldness) and 6 (maximum coldness). Position 'G' is the 'OFF' setting.
Leave the appliance for approximately 4 hours to reach the correct temperature before placing any food inside.